Urgent Driveshaft – 2 hrs

By |9 August 2022|Engineering|

An urgent job came in to remanufacture and replace a driveshaft for a local pharmaceutical company. We did this in a 2 hour turn around. If you need extensive repair work to large rollers or shafts, we have a 3,000mm between centres capacity.

Worn Out Pulley

By |8 August 2022|Engineering|

To replicate a pulley we clean the pulley and take accurate measurements of all dimensions of the bore and keyway and brooch We draw a map, then use our 3 axis CNC machine to reproduce the part.

Steel Profile Replicated

By |8 August 2022|Engineering|

This is a typical job we get where we collect a mechanical part and need to replicate it to create a new version. The lower place is the original rusty plate which was copied to produce the other steel plates.

CNC Turned Rollers

By |1 August 2022|Engineering|

Manufacture and assemble complete rotating assemblies to customers requirements using our CNC and manual machines. Our workshop is fully equipped with Two CNC 3 axis bed mills, CNC lathes , with turning capacity of up to 3000mm between centres.

Carburettor Repair

By |10 July 2022|Engineering|

This Carburettor was cleaned and welded to repair the damaged parts. We specialise in the repair of worn or broken components, typically from electric motors, geared units and pumps.

Go to Top